Hi, I'm Bill from B&B Supply, PriceGunStore.com, and I'll be showing you how to load the labels into the Towa Price Gun. I can imagine that because you're watching this video right now, you're probably pretty frustrated. You feel like throwing your price gun against the wall. But let's not do that. Take a deep breath and realize that in the next two minutes, I'm going to help you have this thing loaded. For a printable version of these instructions, as well as maintenance tips, please visit our website at www.PriceGunStore.com. 

To load the Towa Price Gun, let's first prepare our labels by taking the roll and discarding the labels to where the glue was used to hold it. This is so you don't risk jamming up the machine with the labels that had the adhesive on it. You'll discard about ten or twelve Towa labels. Next, open the pressure plate by lifting up on the plastic piece. Then, slide the label roll holder open, and place the roll on the hub. Make sure the labels are coming off the top of the roll. Feed the label strip over the sprocket pin and through the gun until you have about five inches of labels hanging. Next, insert the strip up through the opening in the print plate. Bend the labels over the top and position the pre-cut holes on the pin of the sprocket wheel. You'll want to lineup the first two labels on the pin. If you have any slack in the label strip, this needs to be backed out until the label strip is tight. Keeping a finger on the labels to help hold the position, close the pressure plate. Begin to click the handle and printed labels should dispense from the top of the Towa label gun. Finally, tear off and discard the backing paper. 

I hope this video has helped you learn how to load the Towa Price Gun. If you have any further questions, please give us a call at 1-800-346-7820, or visit our website at PriceGunStore.com.